Ingersoll-Rand Thermo King TracKing, Руководство по установке

Страница: 26 / 47

24
SB Units Step 3 - REB and Battery Installation
NOTE: These procedures are for SB-30 series
units with factory installed SR-3 Controller
using REB modules.
REB Installation
1. Open the control box door and install the REB module onto the
controller with the supplied hardware.
• Be sure pins are aligned correctly and are not bent.
• When installing the REB mounting hardware, be careful not to
pinch or damage the GPS antenna wire attached to the circuit board.
• REB mounting hardware requires a two-step torque process:
Step 1: Torque to 1.4 N•m (12 in-lbs.)
Step 2: Loosen and re-torque 1.4 N•m (12 in-lbs.)
2. From the SR-3 controller:
• Attach 10-pin connector to RJ5 on REB module.
• Attach 4-pin connector to RJ6 on REB module.
3. Connect 16-pin connector from REB harness to RJ2 on REB module.
4. Attach the antenna cables to the REB. Make sure the antenna and REB
labels match.
• Torque to 1.4 N•m (12 in-lbs.)
5. Support the antenna wires by securing them to the control box with
bandwraps. This will help prevent undue vibration.
Battery and Harness Installation
6. Gain access to the road side condenser shelf and install the provided
bolt plate.
7. Mount the battery assembly under the condenser shelf to the bolt plate
with the provided 10-32 locking nuts and flat washers.
8. Connect the 4-pin connector (BVP, BVN) from the main harness to the
mating connector on the battery charger.
9. Secure excess wires inside control box with bandwraps.
Nameplate Installation
10. Attach the supplied warning label to the front door directly below the
door latch.
Enable Unit for Remote On/Off Commands
1. At the unit, go to Guarded Access Menu.
NOTE: The Guarded Access Menu is not available if the engine is
running.
2. Turn off the engine.
3. Scroll down and select Programmable Features.
a. Remote Device (set to Enabled).
4. Allow TracKing to report to website.
TracKing Verification Procedures
See “TracKing Verification Procedures” on page 38.
CAUTION: When working with electronic circuits that contain
microprocessors, always wear an electrostatic discharge (ESD)
wrist strap. Connect the grounding clip to the chassis ground or
CH terminal to prevent electrostatic discharge from damaging
circuits.