Ingersoll-Rand Thermo King TracKing, Руководство по установке

Страница: 20 / 47

18
Precedent Units Step 6 - Configuration Procedures
NOTE: An additional harness (41-9171 sold separately) is required to
connect the REB and use TDAC.
Configuring Door Switch
1. Reinstall the unit’s negative battery cable.
2. At the unit, go to Guarded Access Menu.
NOTE: The Guarded Access Menu is not available if the engine is
running.
3. Turn off the engine.
4. Scroll down and select Unit Configuration.
a. REB Door Switch enable (set to Enabled).
5. Using TDAC, connect to REB enable the following under Device
Setting:
a. Read Door in Countdown (set to Enabled).
6. The unit is now programed for door switches, press the exit key.
7. In the TracKing website under Administration/Vehicle Maintenance,
enable the following:
b. Door Switch (select check mark in box).
Configuring Fuel Tank
1. Reinstall the unit’s negative battery cable.
2. At the unit, go to Guarded Access Menu.
NOTE: The Guarded Access Menu is not available if the engine is
running.
3. Turn off the engine.
4. Scroll down and select Unit Configuration.
a. REB Fuel Level Sensor Types (set to Solid State or Float to match
type used).
5. Using TDAC, connect to REB enable the following under Device
Setting:
b. REB Fuel Sensor in Countdown (set to Enabled).
6. The unit is now programed for fuel, press the exit key.
7. In the TracKing website under Administration/Vehicle Maintenance,
enable the following:
c. Fuel Tank size value.