Ingersoll-Rand P185AWIR, Руководство по эксплуатации и обслуживанию

Страница: 84 / 92

Operating & Maintenance Manual 4IRI8N - 4IRI8T ENGINE
80
If this is not possible:
• Do not drain the cooling water.
• Clean dust or oil from the engine
extension.
• Either fill completely or drain the
fuel tank.
• Grease accelerator joints and
electrical connections.
• Disconnect the negative battery
terminal.
ENGINE MAINTENANCE
Periodical Inspection and Maintenance
Inspection after initial 50 hours of operation
Replacing the engine oil and engine oil filter
(1st time):
When the engine oil is still hot, be careful with
a splash of engine oil which may cause
burns. Cool the engine to replace engine oil
until the engine oil becomes warm. It is most
effective to drain the engine oil while the
engine is still warm.
In early period of use, the engine oil gets dirty
rapidly because of the initial wear of internal
parts. Replace the engine oil earlier.
Engine oil filter should also be replaced when
the engine oil is replaced.
Engine oil and engine oil filter replacing
procedures are as follows:
1. Prepare a waste oil container
collecting waste oil.
2. Loosen the drain plug using a
wrench (customer procured)
to drain the engine oil).
3. Securely tighten the drain
plug after draining the engine
oil.
4. Turn the engine oil filter
counter-clockwise using a
filter wrench (customer
procured) to remove it.
5. Clean the engine oil filter
mounting face.
6. Moisten the new engine oil
filter gasket with the engine oil
and install the new engine oil
filter manually turning it
clockwise until it comes into
contact with the mounting
surface, and tighten it further
to 3/4 of a turn with the filter
wrench.
Tightening torque: 19.6~23.5N•m
(2.0~2.4kgf•m)
Applicable engine oil filter part no:
22226351
7. Fill with the new engine oil
until it reaches the specified
level as explained in
OPERATION section.
8. Warm up the engine by
running for 5 minutes while
checking any oil leakage.
9. Stop the engine after warming
up and leave it stopped for
about 10 minutes to recheck
the engine oil level with
dipstick and replenish the
engine oil. If any oil is spilled,
wipe it away with a clean
cloth.
10. Resume engine oil and filter
changes at 250 our intervals
(with non IR fluids) or 500
hour intervals with Ingersoll-
Rand Protec™ engine fluid
and filters.
Note: The use of genuine Ingersoll-Rand oil
and filters will qualify for extended warranty
coverage. Refer to Warranty Section of the
manual.