InfoPrint 6500 DBCS, Руководство пользователя

Страница: 59 / 230

59
Interface Selection
Interface selection enables or disables physical interfaces for attachment
switching. If an interface is disabled, it is set offline and any data received will
be ignored.
When coax or twinax is selected, a POR status is sent to the host. Selecting
Autoswitching provides automatic interface switching among parallel, serial,
and either coax or twinax communication. Only one interface can be enabled
at a time. Configuration of the Auto Switching Hotport is done from the
corresponding interface menu, as shown in the following sections.
NOTE: When used with serial, parallel, and coax or twinax emulations,
Autoswitching does NOT save the state of each emulation during
interface switching. In this case, it is the responsibility of the host
application program to initialize the emulation to the desired state as
the beginning of each job. It is also the responsibility of the host
application program to correctly position the forms at “top of form” and
the end of each job.
Display Language
This parameter selects the language in which the operator panel messages
will display.
Print Direction
The PRINT DIRECTION feature affects both print quality and printing speed.
By setting this feature, you can configure the printer to print in both directions
of the shuttle sweep (Bidirectional), or to print in only one direction
(Unidirectional).
You might want to use Unidirectional when printing bar codes, high qualty text
and graphics, or other printing that requires precise vertical alignment.
Although enabling this feature reduces print speed, it enhances the vertical
alignment of dots and produces cleaner, sharper bar codes and text.
•
Bidirectional (the default). Prints all data in both directions of the shuttle
sweep. This choice produces higher printing speed.
•
Unidirectional . Prints all data in only one direction of the shuttle sweep.
This choice produces higher print quality.
Printer Control Menu