InfoPrint 6500 DBCS, Руководство пользователя

Страница: 147 / 230

Fault Correction Procedure
147
150 ERROR: EC STOPPED
AT STATE XXXX No XXXX is a number from
0000 to 0010. The
Entine Controller has
stopped and is in the
state identified by the
number displayed. Contact your InfoPrint
service representative.
159 HAMMERBANK HOT No The hammerbank is
overheating. Contact your InfoPrint
service representative.
160 ERROR: DC PROGRAM
NOT VAILID
No The printer cannot find
the data controller
program or the validation
checksum is corrupt. Contact your InfoPrint
service representative.
161 ERROR: DRAM AT
ADDRESS XXXXXXXX No The printer found a
defective memory
location. Contact your InfoPrint
service representative.
162 ERROR: EC PROGRAM
NOT VALID Yes The printer cannot find
the engine controller
program or the validation
checksum is corrupt. Download the program
again. If the fault
message appears again,
contact your InfoPrint
service representative.
163 ERROR: FLASH DID
NOT PROGRAM Yes The printer encountered
an error trying to
program flash memory. Download the program
again. If the fault
message appears again,
contact your InfoPrint
service representative.
164 ERROR: SDRAM
JEDEC MISSING No The printer could not find
JEDEC table for sdram,
using default values. Contact your InfoPrint
service representative.
165 ERROR: NO DRAM
DETECTED No The printer could not find
any DRAM. Contact your InfoPrint
service representative.
166 ERROR: NVRAM
FAILURE No The non-volatile SRAM
on the controller board
has failed. Contact your InfoPrint
service representative.
167 ERROR: PROGRAM
NEEDS MORE DRAM No The printer requires
more DRAM to run the
downloaded program. Contact your InfoPrint
service representative.
168 ERROR: PROGRAM
NEEDS MORE FLASH No The printer requires
more flash memory to
run the downloaded
program. Contact your InfoPrint
service representative.
Table 8: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution
Fault Messages