InFocus MONDOPAD INF5720, Руководство по оборудованию

Страница: 9 / 37

Page 7 INF5720 & INF5722 Hardware Guide
SETUP
General mounting information
This product ships with a table stand. It does not ship with any other mounting accessories. Only use commercially
manufactured mounting accessories which meet this product's specifications and follow the manufacturer installation
instructions.
• The table stand is for use on desk and table surface only. Do not use the table stand as a floor stand. Injury or
product damage could occur.
• Only use properly rated wall and stand mounting hardware that meet this product’s specifications and follow the
manufacturer installation instructions. The warranty does not cover any damage caused by use of improperly rated
mounting hardware or from improper installation.
• To prevent damage to the screen surface, carefully place your monitor face-down on a clean, cushioned surface.
• When mounting the monitor to a wall, metric 8 (12mm) screws must be used. Use spring washers to prevent the
screws from coming loose. In addition, the mounting interface should comply with the UL1678 standard in North
America. The mounting means should be strong enough to bear the weight of the monitor.
• Do not install the monitor in places subject to mechanical vibration.
• Do not place the monitor on an unstable surface, which could result in serious personal injuries and monitor damage.
When mounting the monitor to a stand, be sure to following the manufacturer’s instructions. Use only the mounting
hardware recommended by the manufacturer.
• Do not install or use the monitor near any heat sources such as radiators, heat registers, stoves, or other devices
(including amplifiers) that produce heat.
• Do not place the monitor in direct sunlight, humid, greasy or dusty places or in places where the monitor may come
into contact with rain, smoke or steam.
• If the monitor is installed against the wall, maintain a distance of at least 1.98” (5cm) between the monitor and the
wall to provide adequate ventilation.
• WARNING: If the monitor is installed against the wall or on a floor stand, the monitor must be securely attached to
the wall or floor stand per installation instructions. Tipping, shaking, or rocking the monitor may cause injury or death.