Infinova V6202-TA Series, Инструкция по эксплуатации

Страница: 8 / 17

25
4.3.2 FTP Settings
Figure 4-11 FTP Settings
V6202-TA series camera has the function of alarm associated with FTP upload
(alarm triggered image snapshot). Configure server IP, user name and password
in the FTP settings and activate FTP handling way in alarm settings, then alarm
triggered images FTP upload can be achieved.
4.3.3 SMTP Settings
Figure 4-12 SMTP Settings
User needs to set mail server, recipient, etc in SMTP settings interface.

Server IP
: Set mail server address.

From:
Set sender’s mail address.

To:
Mail address of recipient.

CC:
Mail address of the person copy to.
26

Authentication
: Enable or disable authentication function. This function
should be set according to authentication requirements of mail server.

User name
: Sender’s name, it can be set according to user’s needs.

Password
: Set sender’s password.
After setting, click “Save” to take effect.
If user selects “mail” in “Alarm Settings” interface, system will send mails
according to SMTP settings.
4.3.4 HTTPS Settings
Figure 4-13 HTTPS Settings
V6202-TA series camera supports HTTPS protocol. You can import the CA
certificate in the interface.
4.3.5 802.1X Settings
Figure 4-14 802.1X Settings
V6202-TA series camera supports 802.1X protocol. You have to enable 802.1X
27
authentication when needed. Then, select an EAP method and enter the user
name and password.
4.3.6 QOS Settings
Figure 4-15 QOS Settings
There are 4 network Qos modes to be selected:
(1) Normal Service
(2) Max Reliability
(3) Max Throughput
(4) Min Delay
Recommend: Normal Service.
4.3.7 IGMP Settings
Figure 4-16 IGMP Settings
V6202-TA series camera supports multicast function. In the IGMP interface,
users can select the stream type and set the state, multicast IP address and RTP
28
port.
4.3.8 SIP Settings
Figure 4-17 SIP Settings
SIP Server:
to configure SIP server for device;
SIP Server IP: the IP address of SIP server;
Port: the port number of SIP server;
Server ID: the ID of SIP server;
Device ID: the device ID used for registration with SIP server;
Alarm ID: the ID registered for device alarm;
Register Interval: the interval for re-registration of device in seconds;
Heat Beat Interval: the interval to send heartbeat information by the device in
seconds;
After configuration completed, click “Save” and the device sends a registration