9
LT5889 issue 7(10/12)
600 CF
Users Instructions
SECTIONTHREE
Cleaning Continued
REMOVING GLASS PANEL
Remove the trim, which is held in
position with magnets.
Remove the two 6mm wing nuts
located on the bottom left hand and
right hand corners of the firebox.
Pull the glass frame assembly
forward to clear the fixing studs.
Once clear pull the glass assembly
downwards to clear the glass
retaining bracket.
Once the fuel bed has been laid
reassemble in reverse order.
SECTION FOUR
Fuel Bed Cleaning and Layout
Before you clean any part of the appliance ensures that the appliance is turned off and cold.
Use only the fuel bed components provided and no additional parts must added.
Incorrect positioning of the fuel bed components could result in the staining of the glass panel.
Important: -
Refer to the ‘Health & Safety Notice located on page 3 of this booklet
before
cleaning or replacing any refractory material.
The fuel bed components are delicate and they should be handled with great care.
The loose parts and moulded shapes may be removed for cleaning. They can be brushed very
gently with a soft brush to remove dust or any deposits.
A vacuum cleaner may only be used after the loose components and moulded shapes have been
removed.
Please make sure no loose shapes are placed directly on top of the pilot head. (Please see
figure below).
CARE SHOULD BE TAKEN TO AVOID CONTACT WITH THE REFRACTORY LINING THIS IS A
DELICATE SURFACE AND SHOULD
NOT
BE WIPED OR RUBBED.
