Infineon XC2000 Easy Kit, Руководство пользователя

Страница: 11 / 36

XC2000
Easy Kit
General Information about XC2000 Easy Kit Board
XC2000 series Board Manual 11 V 0.2, 2008-11
DIP switch S101 allows to configure the startup setting of the XC2000 during RESET.
The default System Startup Configuration is shown in
Table 1 . By default all DIP
Switches are OFF. The XC2000 executes a standard start from internal Flash.
Table 1 Default configuration
2.4.1 Basic Startup Configuration
Name in
schematic
Default configuration Description
S101 Startup configuration:
Standard start from internal Flash
(Default)
Table 2 Basic Startup Configuration with debug support
Startup Mode Debug
Interface CFG pins P10 [3:0]
1)
TRST=1
1)
x means that the level on the corresponding pin is irrelevant.
Internal Start from Flash JTAG pos.B x 0 1 1
DAP pos.1 x 1 0 0
from Flash
2)
2)
A defined location in Flash (C0’01F0
H
) must contain a value (2 Bytes) for DBGPRR register and the next word-
location (C0’01F2
H
) must contain the inverse value.
If the inverse-condition does not match - the value is considered as invalid and JTAG pins at position A are
configured by default.
x 1 1 1
DAP pos.0 0 0 0 1
DAP pos.2 0 1 0 1
3 2 4 1 5
0
1
P10.0 P10.1 P10.2 P10.3 /TRST