Infineon XC2000 Easy Kit, Руководство пользователя

Страница: 29 / 36

XC2000
Easy Kit
Getting Started
XC2000 series Board Manual 29 V 0.2, 2008-11
5.2 OCDS Debugging Interface
The XC2000 Easy Kit offers two types of JTAG interfaces. With the FTDI chip an on
board USB JTAG wiggler has been implemented. Further the USB interface allows to
emulate a USB to UART bridge. Both can be done at the same time.
A simple 16 pin JTAG header can be used to connect a debugger from one of Infineon’s
tool suppliers. Both systems include an On-Chip Debug Support (OCDS) system, which
provides convenient debugging, controlled directly by an external device via debug
interface pins.
5.3 USB Interface for UART support
The USB connector is used for connection to a PC. Via the USB it is possible to power
the board, using the ASC0 as serial connection via USB and Debugging via DAS. For
the pinout of USB socket see Figure 6.
NOTE: Before connecting the board to the PC, make sure that the actual DAS software
is installed on the PC. For actual DAS software please contact your local FAE.
The latest version of the software can also be found on the
DAS website
5.4 MemTool
Memtool is one of Infineon’s solutions for programming code and data into FLASH
Memory. Memtool supports on-chip FLASH Memory as well as dedicated Flash chips on
the target board. It can be used either via ASC bootstrap loder mode or with USB JTAG
wiggler (DAS).
5.4.1 Start Memtool
Go to Target dialog (Target/Change) and select as a example ’ Easy Kit with XC2287 ’
from the list and Click 'ok'.