IMS MDrive34Plus, Руководство по эксплуатации продукта

Страница: 43 / 98

2-15
Part 2: Interfacing and Configuring
Isolated Logic Input Characteristics
Enable Input
This input can be used to enable or disable the driver output circuitry. Leaving the enable switch open (Logic
HIGH, Disconnected) for sinking or sourcing configuration, the driver outputs will be enabled and the step
clock pulses will cause the motor to advance. When this input switch is closed (Logic LOW) in both sinking
and sourcing configurations, the driver output circuitry will be disabled. Please note that the internal sine/cosine
position generator will continue to increment or decrement as long as step clock pluses are being received by the
MDrivePlus Microstepping.
Clock Inputs
The MDrivePlus Microstepping features the ability to configure the clock inputs based upon how the user will
desire to control the drive. By default the unit is configured for the Step/Direction function.
Step Clock
The step clock input is where the motion clock from your
control circuitry will be connected. The motor will advance
one microstep in the plus or minus direction (based upon
the state of the direction input) on the rising edge of each
clock pulse. The size of this increment or decrement will
depend on the microstep resolution setting.
Direction
The direction input controls the CW/CCW direction
of the motor. The input may be configured as sinking or
sourcing based upon the state of the Optocoupler Refer-
ence. The CW/CCW rotation, based upon the state of the
input may be set using the IMS Motor Interface software
included with the MDrivePlus Microstepping.
Quadrature
The Quadrature clock function would typically be
used for following applications where the MDrivePlus
Microstepping would be slaved to an MDrivePlus Motion
Control (or other controller) in an electronic gearing ap-
plication.
Up/Down
The Up/Down clock would typically be used in a dual-
clock direction control application. This setting is also la-
beled CW/CCW in the IMS SPI Motor Interface software.
Input Timing
The direction input and the microstep resolution inputs
are internally synchronized to the positive going edge of the
step clock input. When a step clock pulse goes HIGH, the
state of the direction input and microstep resolution set-
tings are latched. Any changes made to the direction and/
or microstep resolution will occur on the rising edge of the
step clock pulse following this change. Run and Hold Current changes are updated immediately. The follow-
ing figure and table list the timing specifications.
Input Filtering
The clock inputs may also be filtered using the Clock IOF pull down of the IMS SPI Motor Interface. The
filter range is from 50 nS (10 MHz) to 12.9 µSec. (38.8 kHz).
The configuration parameters for the input filtering is covered in detail in Section 2.4: Configuring the
MDrivePlus Microstepping.
Step Clock
Direction
Channel A
Channel B
CW
CCW
Step/Direction Function
Quadrature Function
Up/Down Function
Figure 2.3.4: Input Clock Functions