Visit www.improvedracing.com for additional support
8
Figure 3 - Positioning the 150
°
Hose Ends on ENV-170
29.
Torque all connections on EFR-100 and ENV-170 to 25 lb-ft (34 N-m).
30.
Pre-fill a new oil filter with engine oil and then lubricate the oil filter seal
before screwing it onto ENV-170.
DO NOT over-tighten!
31.
Remove the hose end that was left loose, and then pre-fill MHX-520 when
not using an engine pre-oiler.
32.
Reconnect the hose-end to the adapter fitting.
33.
Torque the fitting to 25 lb-ft (34 N-m).
34.
Check that all oil line connections are torqued to 25 lb-ft (34 N-m).
35. Reinstall the factory steering cooler onto the vehicle using an 8mm tool.
36. Trim the plastic fascia panel located on the front left side of the frame
rail to clear the oil lines, as shown in Figure 4.
