Visit www.improvedracing.com for additional support
11
4.
Remove the fuel pump and / or ignition fuse(s) so that the engine does
not start when turned over.
Consult the vehicle’s factory service manual for the fuse(s) location.
5.
Crank the engine over for five seconds to build oil pressure, repeating
this cycle three to five times.
6.
Reinstall the fuse(s).
7. Start the engine to check for leaks or strange noises while the engine
gets up to normal operating temperature.
Verify engine oil pressure is stable and reading the correct value.
8. Turn-off the vehicle, inspect the engine oil and coolant levels and add oil
or coolant as needed.
9. Take a drive without reinstalling the bumper cover, if possible, and verify
that no leaks or noises occur.
Leaving the final pieces off allows for easier fixes, if required.
Verify test driving the car does not violate local laws regarding bumpers
and headlights before taking the test drive.
10. Verify the car does not overheat to prove coolant levels are properly
filled again.
11. Reinstall the front bumper, headlights and all underbody panels after a
successful test drive.
12. Inspect all parts for loosening or leaks after 100 miles of driving.
Installation is now complete. Thank you for purchasing an Improved
Racing product!