Visit www.improvedracing.com for additional support
5
5. Remove all parts from the bumper bar for drilling.
6. Drill a
3
/
8
inch
hole into the bumper bar using a sharp, high-quality, cobalt
steel drill bit.
The bumper bar is made from hardened steel; a sharp drill bit is required
to cut through it.
7. Use a 10mm tool to secure the mounting bracket to ENV-170 with the
provided M6 screws.
8. Use a 12mm tool to install ENV-170 onto the bumper with the backing
plate using two M8 screws from the hardware kit.
9.
Torque the M8 bracket screws to 20 lb-ft (27 N-m).
10. Reinstall the bumper bar onto the vehicle and use the old paint marks to
get alignment correct.
11. Torque the bumper bar screws according to factory spec.
INSTALLING THE OIL COOLER & BRACKETS
1. Remove the black plastic fascia panel in the driver side wheel well by
using a forked prying tool to remove three push-in fasteners.
Refer to Figure 4 if unsure what panel this is.
2. Use an 8mm tool to remove the power steering cooler from the radiator
support when you car is equipped with a power steering cooler.
3. Use cable ties or string to hang the power steering cooler from the bottom
of the radiator support to reduce stress on the hoses and lines.
4. Familiarize yourself with MHX-520 by reading over the product manual.
5. Locate the EFR-600-60 Bracket Kit, then install the top bracket onto
MHX-520 using the supplied M8 screws and a 12 mm tool.
The ports on MHX-520 face the long arm of the bracket.
6.
Torque the M8 screws to 20 lb-ft (27 N-m).
7.
Use a 1 inch tool to install two OM-10-10 fittings into MHX-520.
8.
Torque the adapter fittings to 25 lb-ft (34 N-m).
9. Use a 12 mm tool and the remaining screws and washers from the EFR-
600-60 Bracket Kit to loosely secure the top bracket to the radiator
support, as shown in Figure 2.