Visit www.improvedracing.com for additional support
6
Figure 2 -
Remote Filter Mount Installed on Front Bumper Bar
10. Locate the EFR-600-61 Hardware Kit, then install the bottom bracket
onto MHX-520 using two M8 screws and a 12 mm tool.
11. Loosely tighten the screws to mark the bracket hole.
12. Verify the oil cooler does not interfere with any factory components and
adjust the top bracket if it does.
13.
Use an angle finder to align MHX-520 parallel with the AC condensor/
engine radiator.
14. Once parallel, trace the outline of the bracket hole onto the bumper bar
with a permanent marker.
15. Remove the lower oil cooler bracket from MHX-520.
16. Loosen the top bracket hardware from the vehicle and carefully remove
the entire cooler and bracket assembly from the vehicle.
17. Strike the hole-center on the bottom of the bumper bar with a sharp
punch.
18. Use a sharp, high quality
7
/
16
inch (11mm) drill bit to cut a hole into the
bumper bar for the lower oil cooler bracket.
19. Apply anti-seize to the included
1
/
4
”-20 screw, then use a
7
/
16
inch (11mm)
tool and the included jack nut wrench to install the jack nut into the
7
/
16
inch (11mm) hole.
Search YouTube videos for “pop jack nut installation” when unsure.