Impediment RS-0800-LVD, Руководство пользователя

Страница: 43 / 58

Operation
31
Chapter 3
Operation
3.1 Before You Begin
Before powering up the enclosure please ensure that all the modules are firmly seated in their correct
bays.
3.2 Power On
Do not operate the subsystem until the ambient temperature is within the specified operating range. If the
drives have been recently installed ensure they have had time to acclimatize before operating them.
Note NotePlease refer to Section 1.2.2.1 for details of the ESI/Ops Panel LEDs and related fault conditions.
Follow the procedure below to power up the enclosure.
1 Apply AC Mains power to the enclosure. Turn the Power Supply modules to ON.
2 All LEDs on the ESI/Ops Panel should be lit (Green) when the enclosure power is activated (and the disk
drive motors should start).
Note All LEDs on the ESI/Ops panel should be lit Green at power up to indicate that the system is functioning
correctly. If any show Amber then a problem exists and the procedure in
Chapter 4 should be followed.
Important If mains power is lost for any reason, on restoration of power the enclosure will re-start
automatically.
3.3 Operator Panel LEDs
The ESI/Ops Panel LEDs are shown in Table 3–1 .
Under Normal conditions the LEDs should all be illuminated constant GREEN.