Impediment RS-0800-LVD, Руководство пользователя

Страница: 27 / 58

Getting Started
15
Chapter 2
Getting Started
2.1 Introduction
In this chapter, you are shown how to install your RS-0800-LVD enclosure and plug-in modules into an
industry standard 19 inch rack cabinet.
Caution When connecting up the RS-0800-LVD subsystem, use the power cords supplied or ones which match
the specification quoted in section
1.5.4 .
2.2 Planning Your Installation
Before you begin installation you should become familiar with the configuration requirements of your RS-
0800-LVD system, detailed in Table 2–1 . The correct positions of each of the optional plug-in modules
are shown in Figure 2–1 . Please refer to Section 2.6 for details of Ultra-320 SCSI configurations and
installation.
Table 2–1 RS-0800-LVD Configuration
Module Location
Drive Bays ALL drive bays must be filled with either a Drive Carrier module or a dummy
carrier module, no bays should be left completely empty.
Power Supply
Modules • One Power Supply module provides power for a full configuration of 8
drives, 2 I/O modules and 2 Cooling modules. Install the module in bay 1
and a Blank Power Supply module in Bay 3
• Two Power Supply modules: provide redundancy with power to the drives
maintained while a faulty module is replaced. Install the modules in bays
1 and 3
SCSI I/O Modules Two modules must be fitted in the top right and left hand rear bays.