Impacts STREAMER S125E, Руководство по эксплуатации

Страница: 33 / 40

Operating Manual S125E
31
Failure Possible Reasons for Failure Failure Corrective Actions
Too much wear in the
wheel housing and
rebound chamber
Wrong position of the control cage
The abrasive flow goes to the
wheel housing and not to the
surface.
Adjust the control cage
Too high abrasive
consumption
Too much air through the system
Reduce airflow by adjusting air
flow opening valve on top of the
separator
Too much abrasive in the hopper
Reduce the amount of abrasive
in the machine
9.2 Diagnosis of Electrical Failures
Prior to any repair work on the machine or its drives, the machine has to be secured
against unintentional switching on. Put the machine to its Safety off position as
described in Chapter 2.
Work on the electrical parts of the equipment have to be undertaken by a skilled
electrician or by a trained person under the guidance and supervision of a skilled
electrician in accordance with the electrical engineering regulations.
Failure Possible Reasons for Failure Failure Corrective Actions
Motor does not start up Missing voltage Check power supply
Faulty Switch
Cable broken
Faulty Plug
Diagnosis and replacement by
electrician
Motor stops during
operation Current too high
Cable Defect Check by electrician
Replace cable
Carbon brushes worn out Replace through an electrician