5
Knowledge and respect of the instructions, safety warnings and danger in this manual are all necessary for installation,
operation, management and machine maintenance with a minimal risk.
The “PLANT SAFETY MANAGER” has the following responsibilities and duties:
- To know the machine functions, its commands, safety and protection devices, possible dangers of use and all the
information in this manual in detail. This knowledge can only be gleaned from detailed reading of this manual.
- To know the safety legislation in force in detail in order to operate the machine
- To recognise the “QUALIFIED PERSONNEL” for transportation, handling, installation, use, maintenance, disposal, etc.
- Correctly train and educate the “QUALIFIED PERSONNEL” before allowing them access to the machine. The
personnel must also be exhaustively trained with regards to the machine’s protection devices.
- Ensure the machine’s safety devices are not tampered with or removed and are checked on a daily basis. Provide the
operator appropriate individual protection devices according to the laws in force.
- The constructor is available for clarification, assistance and training and declines all responsibility for damage to things
or people resulting from improper, incorrect and negligent use by untrained personnel.
1.12 STORAGE
WARNING
The appliance must be stored and conserved in the original packaging and in a
closed environment, protected from atmospheric agents with a minimum
temperature of -15C°, and a maximum of +60C° and a maximum humidity of 70%.
WARNING
The tester, as almost all electronic appliances, must not be put in too cold or humid
environments when not used; otherwise it could not work properly.
Therefore, before its use, it is recommended that the appliance is kept in environments
with a low level of humidity and a minimum temperature of 20°.
1.13
TRANSPORTATION AND MOVEMENT
WARNING
In order to avoid irreparable machine damage, move with care, do not overturn,
protect from rain, do not stack, protect the packaging and its contents from bumps
and sources of heat.
During transportation and movement it is important to avoid bumps, overloading with other packages, exposure to
freezing or heating atmospheric agents, or any other potentially harmful condition to the device, things or people.
Machine transportation and movement must be entrusted to Qualified Personnel who can ensure correct movement.
WARNING
DANGER
Do not transport or move the product should it be impossible to respect
the conditions on the packaging or there be any doubts. Request
information from the constructor.
Chapter 2
INSTRUCTIONS FOR USE
2.01 MAIN FEATURES
- Measurement range: 0 – 3000 µs – reso/- 0,1 µs
- Selection of the ultrasonic impulse amplitude adjustable from 250 to 1000 V
- Measure of the time used by the impulse to cross the material to be tested.
- Single or continuous acquisition procedure with automatic or manual saving.
- Zero calibration with depuration of the time for the impulse to go through the probes.
- Calibration of a default time value.
- Acquisition, processing and filing of the tests data in a up to 30,000 samples storage capacity.
- Mini USB interface for PC connection.
www.impact-test.co.uk
www.impact-test.com
www.impact-testsets.co.uk
