13
2.2 DOMESTIC HOT WATER TEMPERATURE
SETTING ON BOILER SIDE
From the main screen, press arrows
until the
boiler side domestic hot water temperature figure is
displayed (
Fig. 2-3
).
08:50 VE 10/06/11
M04
DHW
Boiler set:
00.0
Boiler temp:
00.0
Fig. 2-3
Press the
button again to make the first reading
(boiler side water T.) blink.
Set as desired by pressing arrows
. At the end,
press button
to confirm and for the next figure (Set
boiler) to start blinking.
After setting the last figure, when button is pressed
the cursor no longer blinks and it is possible to change
screens with buttons
.
N.B.:
these settings are only visible in case the boiler is
connected to the system manager through “MODBUS”.
At the end press button
twice to go back to the
main screen.
2.3 SETTING COMFORT AND REDUCED
ROOM TEMPERATURE
Press the
button to enter the navigation menu.
Press buttons
until selecting menu “01. SET-
POINT”.
Fig. 2-4
N a v i g a t i o n m e n u
06. SERVICE
01. SET-POINT
02.
USER SETTING
Press button
to enter the first room set (Summer).
S e t r o o m
S 0 2
SUMMER WITH FREEZ- ZN 2
Comfort:
25.0 °C
Reduced:
28.0 °C
Humidity:
50.0 %
Fig. 2-5
Press the
button again to make the first value
(Comfort) to flash.
Set as desired by pressing arrows
. At the end,
press button
to confirm and for the next figure
(Low) to start blinking. Proceed in the same way for this
setting then go to the last setting (Humidity).
When button
is pressed the cursor no longer blinks
and it is possible to change screen with buttons
and set the figures of the next room sets (Summer with
cooling, Winter) for each configured area.
Default settings are 25°/20° (summer/winter comfort T.)
and 28°/16° (summer/winter low T.) and 50% (humidity).
The limits for ambient temperature will be from 5° to 35°
and for relative humidity from 30% to 60%.
Note: the new settings will be used at the next time
range variation or temporarily setting the system to
stand-by mode.
At the end press button
twice to go back to the
main screen.
