IMC Networks iMcV-FiberLinX-II, Руководство по эксплуатации

Страница: 25 / 60

NOTE
Default mode is the factory default and is provided as a starting point from which
to configure the iMcV-FiberLinX-II modules. This mode does not provide
adequate management isolation and is not recommended for normal use.
This section describes the Telnet/serial port screens and fields available for configuring
the iMcV-FiberLinX-II modes.
The iMcV-FiberLinX-II modes are configured using the config command from the
Device-Specific Options screen. This opens the Transparent Mode screen or the
VLAN Mode screen depending on the current configuration.
Transparent Mode
The Transparent Mode screen is displayed when the iMcV-FiberLinX-II module is
configured in Default mode or Transparent mode.
Transparent Mode – with either (not both) Data and Optics Mgmt dipswitches
set to on, all traffic passes between Optics and Data port EXCEPT what has
been defined as the Management Domain. The Management Domain can either be
efined as untagged traffic or traffic with a specified VLAN ID. d
In Transparent Mode with BOTH Optics and Data Mgmt dipswitches set to off,
ll traffic passes between the Optics and Data Ports. a
efault Mode – the unit passes only Untagged Packets. D
he unit is currently in Default Mode . T
Enter Y for Transparent Mode, N for no Transparent Mode or <enter> to
move to other options [ Y ]
Transparent Mode Setup Screen
When you enable the Transparent Mode, the next screen is the Transparent Mode
Setup screen:
TRANSPARENT MODE SETUP
Is a VLAN tag required on Management packets? [ N ]
er Y for Extra Tagging. Do you want to enter the Extra Tag mode? Ent
nter N if you do not want Extra Tags [ N ] E
re VLAN Tags required on the EXT Port? [ N ] A
Type S or F3 to save the new information
ype Q of F4 to quit and cancel changes T
Reboot is required for any change to take affect.
In this screen you can set the following parameters:
•
VLAN Tag on Management Packets
•
Extra Tag Mode
•
VLAN Tag on EXT MGMT port
25