Imation
10. Hold Switch
When activated, this slide switch disables the operation of any button pressed. This prevents the user
from accidentally altering device operation.
CAUTION!
If the
HOLD
switch is activated during initial power-on, no power will be applied to the
RipGO!
device since the
PLAY
button is disabled.
11. Open Switch
This switch opens the lid and the disk is immediately spun down. If the device is not currently connected
to a host, then the drive is powered-down. Media removal is prevented during write operations.
12. Line Out/Headphone Switch
Slide this switch to Line Out when using external speakers, and to Headphone when using headphones.
13. Battery Compartment
For safety reasons, the
RipGO!
device is shipped with the battery pack removed from the battery
compartment.
14. Battery Release Clips
The release clips secure the battery pack in the battery compartment.
15. Power Reset Switch Access
If the
RipGO!
device stops responding, insert and push a pin into the reset access hole on the underside
to activate the reset switch. This will reset the
RipGO!
device.
16. LED
The LED is tri-color: green, red and orange.
The LED is orange when a disc is spinning up.
The LED is green when a disc is being accessed.
The LED is red when a write (or test write) operation is in progress.
10
Device User’s Guide
Drive State
LED
No disc inserted
Off
Disc loading
Blinking orange
Disc loaded and ready
Solid green
Disc in/power save/non powered mode
Off
Read or verify activity
Blinking green
Writing
Solid red
Test write
Blinking red
