Imagine Videotek LLM-1770, Инструкция по установке и эксплуатации, Страница: 24 / 122

ETHERNET
POWER 11 - 17 VDC
LTC/GPI
SDI AES IN
OUT IN 4 3 2 1
LLM- 1 770
Ethernet
Ethernet
1 0Ba s e-T or 1 00Ba s e-T hu b
To LAN
OPTIONAL
Chapter 2
Installation
18
Figure 2-4 LLM-1770 Network PC Connection
4 Set up an Ethernet configuration for the LLM-1770 as follows:
a Press the SETUP button on the LLM-1770 front panel.
b Press the Up/Down arrow button to scroll to the Unit Configuration Setup menu, and
then press the
ENT button to enter the submenu.
c Press the Up/Down arrow button until the IP selection option is shown.
d Press the ENT button or Left/Right arrow button to enter the Ethernet Config selection
option.
e Select DHCP Control , and then press the ENT button, or use the right arrow to scroll
to the next selection. (Use the Up/Down arrows to change the selection.)
f Once enabled, the obtained DHCP address can be viewed through IP

IP Address
g If using DHCP:

Press the Left/Right arrow button to select DHCP .

Press the Up/Down arrow button to toggle the state to ON .

Press the ENT button.
The IP Address is retrieved from the DHCP server and placed under the appropriate
submenu.
h If not using DHCP:

Press the Left/Right arrow button to select IP ADDRESS .

Press the Up/Down arrow button to change the value selected, and then press the
Left/Right arrow button to select the next value.

Repeat for the remainder of the IP address, subnet mask, and gateway. To avoid
conflicts, the static IP address, subnet mask, and gateway should be obtained from
the system administrator.

Press the ENT button to accept the entered values.
i Press the EXIT button to exit the submenu.