Imagine communications DAC6800 plus BCA4, Инструкция по установке и эксплуатации

Страница: 33 / 59

20 DAC6800
+
BCA4 and DAC6800
+
BCA4Z Installation and Operation Manual
Chapter 2: Installation
8. In the third field, enter the slot number of the module, and then
close the window.
You can now continue upgrading your device’s firmware, starting with
step 3 in
“Upgrading the Firmware in Boot Loader Mode” on page 16 .
Correcting a Failed Upgrade Procedure
Firmware upgrades may fail in the event of network interruptions,
power failures, or if files were sent to the wrong 6800
+
module.
These problems can be corrected by re-installing the firmware using the
File Transfer tab of the Configuration window, as described below.
When you are performing this procedure, check the appropriate readme
file to confirm which files are needed. Use care to ensure that you
upload the correct files to the intended module.
Follow these steps to correct a failed upgrade procedure:
1. Download the most recent appropriate upgrade package from our
Web site or from your CD-ROM.
2. If the affected module has not been discovered by your CCS
software application, enter Build mode, and then drag or copy and
paste the module’s device icon from the catalog folder into the
Network or Discovery folder.
3. Right-click the device icon, and then select Properties .
4. On the Device tab of the Navigation Properties box, enter the IP
address of the frame that holds the module in the second field of the
Device ID . (See Figure 2-15 .)
Figure 2-15. Navigation Properties Box
Note
To successfully upgrade the
firmware, you must follow these
steps in the exact sequence
described.
Caution
Do not make changes in the last
field (located above and to the
right of the
Set Default button.)
Making changes to this field
could cause loss of
communication between the
module and your CCS software.
If communication is lost, you
will need to rediscover the
module.
Do not make changes in
this field
Enter frame IP number here