Imagine communications DAC6800 plus BCA4, Инструкция по установке и эксплуатации

Страница: 29 / 59

16 DAC6800
+
BCA4 and DAC6800
+
BCA4Z Installation and Operation Manual
Chapter 2: Installation
Upgrading Module Firmware
Firmware upgrading is a routine procedure that you must perform to
install newer versions of software on 6800
+
modules. Pilot, Co-Pilot, or
Navigator software version 3.1.1 or later is required for this procedure.
The frame must contain or be connected to another frame that contains
an ICE6800
+
module.
When performing the upgrading procedure, check the appropriate
readme file to confirm which files are needed. Use care to ensure that
you upload the correct files to the intended module.
In the unlikely event that the upgrade fails, the module may not respond
to controls and will appear to be non-functional. In that event, follow
the procedures described in
“Correcting a Failed Upgrade Procedure”
on page 20 .
Upgrading the Firmware in Boot Loader Mode
Upgrading the Firmware Using the Discovery Method
Follow these steps to upgrade a module’s firmware:
1. Download the most recent appropriate upgrade package from our
Web site or from your CD-ROM.
2. Remove the module from the 6800
+
frame.
Figure 2-11. Buttons on a Typical Card Edge
3. Set the hex switch to F.
4. While pressing the Navigation toggle switch down, reinsert the
module into the frame and then release the Navigation toggle
switch.
Note
Firmware for the
DAC6800
+
BCA4 and
DAC6800
+
BCA4Z must be
updated in Boot Loader mode.
Mode select rotary
(hex) switch
Navigation toggle
switch