Imagine communications DAC6800 plus BCA4, Инструкция по установке и эксплуатации

Страница: 24 / 59

DAC6800
+
BCA4 and DAC6800
+
BCA4Z Installation and Operation Manual 11
Chapter 2: Installation
Setting the REM/LOC Jumper for Remote or Local Control
Follow this procedure to set the REM/LOC jumper for either local or
remote control:
1. Locate jumper
REM/LOC on the module (beside the extractor
handle).
See
Figure 2-1 on page 10 for the location of the jumpers.
2. Place a jumper on pins 1 and 2 to set the module for Remote
control, or pins 2 and 3 to set the module for Local control.
See Figure 2-2 .
Figure 2-2. Jumper Settings for Local and Remote Control
See Table 1-1: "Generic 6800
+
Module Features" for more information
on local/remote control jumper functionality.
Note
You need to configure modules
for local or remote operation
prior to power-up. To change
the configuration, first remove
power from the module, reset
the jumper, and then reapply
power.
The white triangle near the
jumper pins on the module
indicates pin 1.
Remote control setting
Local control setting
3 2 1 3 2 1