Getting started
Image Engineering
UCM Universal Camera Mount
Seite
8
von
9
2.2.5 Covering reflective/ light emitting parts during measurements
Depending on your setup and device under test, you might encounter unwanted stray light in
your measurements. To counter this, we included a piece of thick, black molleton with a size of
85x85 cm. Since DUTs vary greatly in shape and size, we have not prepared a cutout but leave
it up to you to apply a cutout that best suits your requirements.
2.3 Preparing UCM variant 2
If you need a Z-rail longer than 350mm, please let us know when you place your order or
preferably beforehand.
Figure 6: Additional holes for mounting required
The Z-rail for UCM variant 2 is supplied without any holes. Figure 6 shows an example of how
the rail could be prepared for mounting.
UCM variant 1 for example is delivered with holes with a diameter 5.5mm. To ensure sufficient
stability, it is not recommended to use a smaller drill diameter and/or screws smaller than M5.
For assembly work, the Z-slide holding the cross focusing rack easily slides on and off each end
of the Z-rail.