Introduction
Image Engineering
UCM Universal Camera Mount
Seite
3
von
9
1 INTRODUCTION
Important information: Read the manual carefully before using the device.
Inappropriate utilization may cause damage to the device, to the DUT (device under test) and/or
other components of your setup.
Keep these instructions in a safe place and pass them on to any future user.
1.1 Intended use
Camera alignment system based on a linear guidance in combination with a cross focusing rack
and ball head allows adjustment of the DUT along X, Y and Z axes. Fix the end position with the
locking wheels.
•
Only suitable for indoor use.
1.2 Product variants
UCM is available in two variants:
•
Variant 1: with rectangular frame and adjustable feet to place device on any flat surface
•
Variant 2: without frame (Z-rail is then screwed directly to the place of operation.
Please note
: drilling additional holes suiting your setup will be required).
1.3 Foreseeable missuse
1.3.1 Stuck linear guidance / ball head
If you cannot turn the wheels for X, Y and Z translation or the ball head, loosen the locking
wheels and check the ball head joint and any moving parts for debris.
1.3.2 Hot/cold environment
If you use UCM in a very hot or cold environment (for example in combination with iQ-Climate
Chamber), please allow the device to approach room temperature again before manipulating it
to avoid injuries or mechanical failure.