iLight SCI0405, Инструкция по эксплуатации

Страница: 11 / 24

Service Switches and LEDs
10 of 23
These switches and LEDs are located at the base of
the unit.
The two service switches on the source controllers
are used for the following:
l
Entering Diagnostic Mode.
l
Putting the Source Controller in override
mode.
l
Sending a message to identify the device on
the network.
Sending a message to identify the device on the
network.
The LEDs indicate the following:
l
Normal operation.
l
Message transmission and receipt.
l
Override status
ICANnet error status will occur when a Source
Controller is not connected to an iCAN network for
any reason. Once either connected to a network of
one or more other devices which are powered the
error status will be removed. It is still possible to
enter Diagnostic mode if a Source Controller is in
iCANnet error status.
INTELLIGENT CONTROLS