ECODRILL 2000 CODE
Operating manual - English
6
GENERAL
ECODRILL 2000 CODE has been designed in compliance to the European Community normative (CE).
From the design stage, risks for the operator have been eliminated in all areas: transport, regulation,
cutting and maintenance.
Further risks have been eliminated by means of protective devices.
The protective devices used are designed not to provoke further risks and, above all, they cannot be
ignored unless deliberately cut out. They do not hinder visibility of the work area.
A special adhesive label is attached to the machine warning the operator to use goggles during the
cutting operations, and this is strongly recommended in this manual.
The materials used to manufacture this machine and all its components are not hazardous.
Use
The ECODRILL 2000 CODE must be installed and used in the way laid down by the manufacturer.
If the key-cutting machine is used differently or for purposes different from those described in this
manual, the customer will forego any rights he may have over Ilco Orion. Furthermore, unforeseen
danger to the operator or any third parties may arise from incorrect use of the machine.
Negligence in the use of the machine of failure on the part of the operator to observe the instructions
given in this manual are not covered by the guarantee and the manufacturer declines all responsibility in
such cases.
It is therefore indispensable to read the operating manual carefully in order to make the best use
of the ECODRILL 2000 CODE sand benefit from its potential.
Further risks
No further risks will arise when properly using the ECODRILL 2000 CODE.
Protection and safety precautions for the operator
The ECODRILL 2000 CODE key-cutting machine is entirely built in compliance to the Machine
Directives. The operations for which it has been designed are easily carried out with no risk to the
operator.
The adoption of general safety precautions (wearing protective goggles) and observation of the
instructions provided by the manufacturer in this manual eliminate all human error, unless deliberate.
ECODRILL 2000 CODE is designed with features which make it completely safe.
•
Power supply
The machine is supplied with electricity by means of a grounded plug and differential switch.
•
Electric power
The machine is started up by means of the master switch.
•
Start-up
The motor start switch activates the cutting tool.
•
Illumination
The work area is illuminated by a lamp which operates when the machine is switched on with the master
switch.
•
Maintenance
The operations to regulate, service, repair and clean the machine are structured in the simplest and
safest way possible. Parts that the operator can dismount cannot be incorrectly replaced therefore
avoiding any risks.
•
Machine identification
The machine is provided with an identification label which includes the machine’s serial number (fig. 2).
Fig. 2
(*) see chap.10 WASTE DISPOSAL, page 38.
