IKH XW034, Инструкция по эксплуатации

Страница: 27 / 30

27
1. Machine cannot be switched on. Cause:
- No main voltage. Check power supply.
- Carbon brushes worn. Take the machine to an authorized service center.
2. Machine switches itself off when idling. Cause:
- Mains failure (check mains back-up fuse). Renew fuse.
3. Machine stops while planing is in progress. Cause:
- Blunt knives or excessive feed rate. Replace or sharpen knives or reduce feed rate.
4. Speed drops while planing is in progress. Cause:
- Cutting depth too great. Reduce cutting depth.
- Feed rate too fast. Reduce feed rate.
- Blunt knives. Sharpen or replace knives.
5. Unsatisfactory finish. Cause:
- Blunt knives. Sharpen or replace knives.
- Uneven feed. Plane with constant pressure and reduce feed rate.
- Not connected to dust extractor unit (not supplied). Connect to it.
6. Chip ejection blocked while planing is in progress. Cause:
- No dust extractor unit. We recommend to use a dust extractor unit while using the machine.
- Wood too damp.
7. Uneven feeding rate while rotary planing is in progress. Cause:
- Rubber belt too loose. Check the rubber belt and change if necessary.
- Clean the dust from the two springs located on the side cover.