IKH XW034, Инструкция по эксплуатации

Страница: 22 / 30

22
9. The anti-kickback device of the planer must be checked regularly to ensure that it remains in
proper working condition. All pawls of this device must move freely and must drop down by
their own weight when lifted. The point of these pawls must be kept sharp.
10. Do not begin planing until the cutter head has reached full speed.
11. When planing, take up a working position so that you are always on one side of the machine
away from the area directly in front of or behind the cutter head.
12. Always keep your hands well away from the cutter head or the chip ejection area while the ma-
chine is running.
13. A uniform feed rate when planing increases the life of the knives and reduces the risk of acci-
dents.
14. The planing knives must be sharpened or replaced in good time as blunt knives do not only in-
crease the risk of kickback, but also impose an unnecessary load on the motor.
15. The knives must be properly mounted and clamped (see chapter “Changing the knives”).
16. Before changing the knife and eliminating malfunctions (including the removal of trapped
chips), pull out the mains plug.
17. The sawdust created by planing makes it difficult to see as clearly as necessary and can impair
operator’s health in certain circumstances. Therefore the machine must be connected with the
dust extraction port to an extractor unit, such as a small portable dust extractor. When operating
for a long period, the air velocity must be at least 20 m/s.
18. The sound pressure level at the workplace generally exceeds 85 dB(A). Users should therefore
wear ear protectors.
19. When operating the machine, use of a circuit breaker is recommended.
20. Any work on the electric components of the machine must be carried out only by a qualified
electrician.
21. Only original spare parts and accessories must be used. Otherwise the manufacturer does not
offer any warranty and does not accept any liability.
22. Regular cleaning of the machine is an important safety factor. Before beginning this task, pull
out the mains plug.
SPECIFIC SAFETY INSTRUCTIONS FOR SURFACE/ROTARY PLANER
WARNING! Before connecting the machine to a power source, be sure that the voltage supply is
the same as that specified on the name plate of the machine. A power source with a voltage greater
than that specified for the machine can result in serious injury to the user, as well as damages to the
machine. Using a power source with a voltage less than the name plate rating is harmful to the mo-
tor. If in doubt, do not plug in the machine. Always remove the plug from the mains socket before
making any adjustments or maintenance, including changing the blades.
1.
An extension cord should not be used unless absolutely necessary. In such case, make sure that
the extension cord and plug match the tool cord and plug by type, size, shape and other qualifi-
cations and that it is properly wired and in good condition. Do not use extension cord with di-
ameter smaller than 2,5 mm
2
or length longer than 20 m, otherwise the motor may be damaged.
2. Ensure that you have removed foreign objects such as nails and screws from the workpiece be-
fore commencing.
3. Rags, clothes, cords, strings and similar should never be left around the work area.
4. Damaged or contaminated workpieces may cause to hazards. Metal parts and splintery work-
pieces penetrated into the workpiece can be very dangerous.
5. Use safety equipment including safety goggles or shield, ear protection, dust mask and protec-
tive clothing including safety gloves.
6. Check to make sure that all fixing screws are tight before operating the machine.
7. Ensure that the dust extractor is in place before commencing operating.