Ikegami BSH-300, Руководство по эксплуатации

Страница: 29 / 54

䠏䠊㻸㻯㻰㻌 㻿㼏㼞㼑㼑㼚㻌 㻟㻙㻣㻌
㻮㻿㻴㻙㻟㻜㻜㻌㻔㼁㻕㻌㻔㻱㻕㻌㻝㻠㻜㻡㻌㼂㻱㻾㻞
ձ
IP ADDRESS
Sets the IP address of this device. The IP address that is set here will be the IP address
corresponding to the CP back connector 1. This IP address will be displayed on the
initial screen. The setting procedure for the address is described below.
I.
Open the menu screen. Press the MENU switch in the NETWORK, and then press
MENU switch in IP ADDRESS to open the settings screen for IP address.
The default address is set at the factory.
II.
When the setting screen for IP address is open, the value of the address to be
changed is displayed with underline.
㻵㻼㻌㻭㻰㻰㻾㻌㻻㻯㻼㻌㻯㻴㻝
㻝㻥㻞㻚㻝㻢㻤㻚㻜㻜㻝㻚㻞㻝㻜㻌
Turn the MENU switch to move the underline and select the value you want to
change.
III.
Once the value is selected, press the MENU switch. The part used to be underlined
will be inverted and flashes.
㻵㻼㻌㻭㻰㻰㻾㻌㻻㻯㻼㻌㻯㻴㻝
㻝㻥㻞㻚㻝㻢㻤㻚㻜㻜㻝㻚㻞㻜㻜㻌
Turn the MENU switch in this state to change the selected value. Turn the switch
right to increase the value, and turn the switch left to decrease it. Sets the address
to the value between 0 and 255. If you press the CANCEL switch while changing
the value, it will revert to the value it was before you changed it.
IV. Once the value is selected, press the MENU switch. The IP address will be
confirmed.
V.
By switching the values of CH
ۑ
between CH1 and CH6 on the right upper corner of
the LCD screen, you can switch the displays of the IP addresses of CP back cables
from 1 to 6 and change their values.
㻵㻼㻌㻭㻰㻰㻾㻌㻻㻯㻼㻌㻯㻴㻟
㻝㻥㻞㻚㻝㻢㻤㻚㻜㻜㻝㻚㻞㻝㻞㻌
You can change the values for CH2 to CH6 only when the "IP ADDR.SETTING"
in
յ
is set to "RANDOM". When it is set to "SEQUENCE", you can switch the
displays but cannot change the values.
* The subsequent procedure for the address setting is omitted as it is the same as the
above.
ղ
SUBNET MASK
Sets the subnet mask of this device.
See "3.3.1 A-Type menu
ձ
IP ADDRESS" for the procedure of
setting the address.