Ikegami BSH-300, Руководство по эксплуатации

Страница: 20 / 54

㻞㻙㻞㻌 䠎䠊㻼㼍㼞㼠㻌㻺㼍㼙㼑㼟㻌㼍㼚㼐㻌㻲㼡㼚㼏㼠㼕㼛㼚㼟㻌
㻮㻿㻴㻙㻟㻜㻜㻌㻔㼁㻕㻌㻔㻱㻕㻌㻝㻠㻜㻡㻌㼂㻱㻾㻞
1. RESET switch
This switch is a reset switch for BSH-300. This switch can reset BSH-300 when an
abnormality occurs. Press the switch with a pointed object.
2.
LCD screen
This screen displays information on this product, various error displays, and menu screen, etc.
3. MENU switch
Press and hold the MENU switch for approximately 3 seconds while the initial screen
(BSH-300) is displayed on the LCD screen to display the menu screen. This switch also serves
as a rotary encoder switch. Rotate it to switch pages and settings. It is also used as an "Enter"
button by pressing the switch.
4.
CANCEL switch
Press this switch to bring one hierarchy back for the page that is displayed on the LCD screen.
5.
RX status indicator
TA communication indicator per line for the CP back connector. It lights up in yellow when the
data is received from the device (control panel, BS/CCU, etc.) that is connected via CP
connector. It lights up in green when the device connection is established on the Ethernet
while communicating with the device that is connected via CP connector. Then, it lights up in
red when an abnormality is detected in the communication with the device that is connected
via CP connector.
The Type-A and Type-B has 6 lines for indicators and Type-C has 3 lines (indicators 4, 5, and 6
are not supported) according to the number of connectors by the BSH-300 type.
It may temporarily light up in red when you operate the items for which the process
speed of the camera head and BS/CCU is slow on the control panel.
6.
Ethernet status indicator
An indicator used to display the communication status of the LAN back connector. It lights up
in green when the communication between the LAN connector and the devices such as
BS/CCU and control panels is being executed or enabled.
7.
ALARM LED
The red light turns on if an abnormality is detected in the temperature, power supply, or
battery of this device. Check the information display "ALARM INFO" displayed on the LCD
screen for details of the abnormality.
8.
USB connector
This connector is used to connect USB device to update the firmware or perform other tasks.
9.
Fuse (AC200-240V:AC250V T1.6A/AC100-117V:AC250V T3.15A)
Fuse is activated when abnormal current is detected in this device. Replace the fuse and then
press it in after removing the cause.
10.
Power switch
This switch is used to turn off the device. "I" is power ON, "O" is power OFF. 㻌