TROUBLE SHOOTING
If you encounter problems with your fireplace system, the problem may be with either the fireplace itself or with the remote. Review
the fireplace manufacturer’s operation manual to make sure all connections are properly made. Then check the operation of the
remote in the following manner:
•
Make sure all batteries are correctly installed in the transmitter. Also check that the batteries are fully charged.
•
Check batteries in transmitter to make sure contacts are touching (+) and (-) ends of battery. Bend metal contacts in for tighter fit.
•
Be sure receiver and transmitter are within 20 to 25-foot operating range.
•
Keep receiver from temperatures exceeding 170º F.
•
If receiver is installed in a tightly enclosed metal surrounding, the operating distance will be shortened.
•
Make sure the hand-held transmitter and remote receiver are communicating properly (see LEARNING TRANSMITTER TO
RECEIVER section).
FCC REQUIREMENTS
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODI-
FICATIONS TO THE EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT
REV. 1-8-15 Page 6
IHP: RC-S-MODMV
P/N 900258-00 Rev. B
HOW TO REGISTER A CLAIM AGAINST WARRANTY
In order for any claim under this warranty to be valid, you must contact the IHP dealer/distributor from which you
purchased the product. If you cannot locate the dealer/distributor, then you must notify IHP in writing. IHP must be
notified of the claimed defect in writing within 90 days of the date of failure. Notices should be directed to the IHP
Warranty Department at 1508 Elm Hill Pike, Suite 108; Nashville, TN 37210 or
visit our website at www.IHP.us.com
LEARNING TRANSMITTER TO RECEIVER
This transmitter has one of 1,048,576 unique security codes. It may be necessary to program the remote receiver to “learn” the security
code of the transmitter upon initial use, if batteries are replaced, or if using a replacement transmitter.
•
Make sure the receiver’s slide switch is in the
REMOTE
position.
•
Press and release the
LEARN
button on the receiver.
•
When you hear the “Beep”, press and hold the
MODE
button for about 2 seconds on the transmitter.
•
If you not hear a beep after you press the
LEARN
button, check the power cord from the receiver and ensure it is plugged in and
has power.
•
You will then hear a series of beeps that indicate that your new transmitter has been accepted by the receiver.
