IHI IHIMER CARRY 107, Руководство по эксплуатации

Страница: 9 / 48

1 SAFETY
MINIDUMPER
CARRY 107
3
1.6 MAINTENANCE
1. ROUTINE MAINTENANCE.
I Maintenance work can be dangerous if it is not done with the due
precautions. Personnel involved in this work should fully understand the
hazards and follow suitable safety procedures. Before performing any
maintenance or repair work, always consult the instruction manual. Prior to
ANY maintenance work, stop the engine and block the machine to prevent
any movement that could cause harm to the operator.
NEVER ALLOW anyone to work on the raised undercarriage if not perfectly
locked. Make sure that the machine is securely supported on blocks. Never
leave the machine lifted only on the boom.
2. MACHINE CLEANING.
Always keep the machine clean. Remove any dirt or grease and check the
tools provided. Never leave anything inflammable in the working area of the
machine.
3. HYDRAULIC PRESSURE ADJUSTMENT.
Skilled personnel may measure and adjust the hydraulic pressure following the correct procedures and using suitable
gauges. If skilled personnel are not available, consult your local distributor.
4. FIRE OR EXPLOSION PREVENTION.
Always leave fuel, lubricants and coolant fluids away from possible sources of fire or heating. Most fluids are highly
inflammable.
NEVER REFUEL and do not lubricate with the engine running.
NEVER SMOKE while refuelling or in places close to inflammable materials.
5. ELECTROLYTIC BATTERY MAINTENANCE.
Do not touch the internal battery elements.
Battery acid burns the skin and can cause blindness if it is splashed into the eyes.
In the event of contact with the acid, rinse the skin contacted with lots of water.
Use bicarbonate of soda to neutralise the acid.
If the acid gets in your eyes, rinse thoroughly and call for medical treatment immediately.
During battery servicing, remember that charging or discharging generates a highly explosive mixture of hydrogen and
oxygen.
A flame or spark can ignite these gases.
Always wear protective
glasses and gloves when working with the battery.
6. HYDRAULIC SYSTEM MAINTENANCE.
Before disconnecting a hydraulic line on the machine, be sure that:
-
the shovel, if present, is on the ground
- the tool holder is in the lowered position
- the engine is off
- the pressurised air has been relieved from the hydraulic tank
- the control levers are moved repeatedly to lower the pressure in the pistons.
Before switching on the engine, make sure that all the connections are firmly tightened and that all the pipes and fittings
are in good conditions.
Fluid escaping from a small hole can be almost invisible. Use a piece of paper or wood, instead of your hands, to
search for suspected leaks.
If you are struck by escaping pressurised hydraulic fluid, serious reactions can occur if proper medical treatment is not
administered immediately.