IgniteNet SkyFire AC1200, Быстрый старт

Страница: 8 / 63

– 18 –
Chapter 1
| Introduction
Setup Wizard
■
Guest Network Setup — Set the name and password for the guest wireless
network. This creates a second SSID for guest users, limiting their access
only to the Internet.
◆
Advanced Setup — Networking modes for AP Bridge, AP Router, or manual
configuration.
Figure 5: Advanced Setup
■
AP Bridge Mode — Configures an interface as attached to the WAN (that is,
the Internet). In the following figure, Ethernet Port 0 and Ethernet Port 1 are
both attached to the WAN. Traffic from these interfaces is directly bridged
into the Internet. (This is also called bridge to Internet.)
Figure 6: Bridge to Internet
■
AP Router Mode — Configures an interface as a member of the LAN. In the
following figure, Ethernet Port 1, Wireless LAN 0 (5 GHz Radio), and Wireless
LAN 1 (2.4 GHz Radio) are all included in the LAN. Traffic from these
interfaces is routed across the access point through Ethernet Port 0 to the
Internet. (This is also called route to Internet.)
Note: Single ‐ band access points only support one WLAN.