Igloo J2SCRP, Инструкция по эксплуатации

Страница: 11 / 14

REFRIGERATION LTD
Pastry Cases | www.igloorefrigeration.com 11
c0 compressor and fan start delay on power-up 1 min 0 100
c1 minimum time between consecutive compressor starts 1 min 0 100
c2 minimum compressor off time 1 min 0 100
c3 minimum compressor on time 0 min 0 100
c4 compressor on time with duty setting 50 min 0 100
cc continuous cycle duration 2 2 0 15
c6 temperature alarm bypass after continuous cycle 2 h 0 15
d0 type of defrost 0 - 0 4
dI interval between defrosts 8 h 0 199
dt end defrost temperature set point 12.0 °C -50 130
dP maximum defrost duration 60 min 1 199
d4 defrost when switching the instrument on 0 - 0 1
d5 defrost delay on power-up or when enabled by digital input 0 min 0 199
d6 freeze control temperature display during defrost 1 - 0 1
dd dripping time 2 min 0 15
d8 alarm bypass time after defrost 1 h 0 15
d9 defrost priority over compressor protectors 0 - 0 1
d/ defrost probe reading (2) - °C - -
dC time base 0 - 0 1
A0 alarm and fan temperature differential 2.0 °C -20 +20
AL absolute/relative temperature for low temperature alarm 0.0 °C -50 +99
AH absolute/relative temperature for high temperature alarm 0.0 °C -50 +99
Ad temperature alarm delay 0 min 0 199
A4 3rd input configuration 0 - 0 11
A7 digital input alarm delay 0 min 0 199
A8 enable alarm “Ed” (end defrost by timeout) 0 - 0 1
AC set point dirty condenser alarm 60 °C -50 250
AE dirty condenser alarm differential temperature 3.0 °C 0.1 20
Acd dirty condenser alarm delay 0 min 0 250
H0 serial address 0 - 0 207
H1 AUX output configuration 0 - 0 2
H2 enable keypad 1 - 0 2
H4 disable buzzer 0 0 1
H5 ID code (read-only) 1 - 1 +199
EZY restore the Default settings 2 0 0 1
5. MAINTENANCE

Before you start Maintenance on the unit, Power it OFF.

Do not use steel wool, abrasive cleaners, bleach or cleaners containing chlorine or sodium to clean the unit.

Do not use a pressure washer or water-jet to clean the unit.

The unit should be cleaned right after unpacking and before turning it on.

The unit should be cleaned with warm water and a mild soap.

Make sure to cover the fan motor to prevent moisture damage.

Door gaskets, shelves and supports should be cleaned on a regular basis.

Fan blades and guards should be cleaned with a soft cloth.