IFM Electronic efector 600 TN21 Series, Руководство по эксплуатации

Страница: 13 / 19

13
UK
8.2 Explanation of the menu
SP1 / SP2 Set point (upper limit value) with hysteresis function
rP1 / rP2
Reset point (lower limit value) with hysteresis function
FH1 / FH2 Set point (upper limit value) with window function
FL1 / FL2 Set point (lower limit value) with window function
ASP2
Analogue start point
AEP2 Analogue end point
EF Extended functions� Opening of the lower menu level�
rES Restoring the factory settings
ou1 Output function OUT1 (switching output):
Hno = Hysteresis function normally open
Hnc = Hysteresis function normally closed
Fno = Window function normally open
Fnc = Window function normally closed
ou2 Output function OUT2 (switching output or analogue output):
Hno = Hysteresis function normally open
Hnc = Hysteresis function normally closed
Fno = Window function normally open
Fnc = Window function normally closed
I = current signal 4���20 mA
I
neg
= current signal 20���4 mA
U = voltage signal 0���10 V
U
neg
= voltage signal 10���0 V
dS1 / dS2 Switching delay on OUT1 / OUT2 in seconds
dr1 / dr2
Switch-off delay on OUT1 / OUT2 in seconds
FOU1 /
FOU2
Behavior of output OUT1 / OUT2 in case of an internal fault�
1� Switching output (FOU1 / FOU2):
On = Output 1 switches on in case of a fault�
OFF = Output 1 switches off in case of a fault�
2� Analogue output (FOU2 → 4.2.1 ):
On = The analog signal goes to the upper limit value�
OFF = The analog signal goes to the lower limit value�
uni Standard unit of measurement for temperature (°C or °F)
P-n Output logic: pnp / npn
Lo
Minimum value of the temperature measured in the process since the last
reset or deletion of memory�