User manual
DUM1017795-EN
16
Input harness connection
1. Loosen the Harting connector locking tab nuts (x2)
- position
❶
2. Remove the locking tab - position
❷
3. Push on the Harting connector locking lever - po-
sition
❸
4. Connect the input harness
5. Pull the connector locking lever
6. Mechanically lock the input Harting connector
by placing back the locking tab under the Harting
connector locking lever
7. Tighten the locking tab nuts (x2)
I
WARNING
Be sure to mechanically lock the connectors before
connecting the charger to the mains or to the EV.
❶
❷
❸
Input harness connection
1
Note:
Visual inspection of the circuit breaker status is
possible through the transparent cover of the circuit
breaker hatch.
If the circuit breaker is in the down position (disabled)
you must reset it by following the steps below:
1. Remove the screws (x6) from the circuit breaker
hatch on the right side of the charger - position
❶
2. Remove the circuit breaker hatch cover - position
❷
3. Reset the charger internal input circuit breaker
(upper position) - position
❸
4. Close the circuit breaker hatch
5. Fix the circuit breaker hatch cover using the screws
(x6)
G
Recommended torque:
2 N.m
❶
❷
❸
❶
Reset the circuit breaker
2
