2.1.1.2
Connecting the Printer to the Data Communications
System
CAUTION
To comply with class A FCC regulations it is
necessary to use a data cable provided with a braided
shield.
Use a shielded RS232 cable fitted with metal plated
connector hoods. The cable shield must be linked to
these hoods and cable length must not exceed 15 m
(49.2 ft).
The length of a USB cable must not exceed 5 m
(16.4 ft).
Depending on the printer configuration, connect either
the:
- serial data I/O cable (1) to the RS232 connector,
located at the rear of the printer, or the
- USB cable (2) to the corresponding connector at the
rear of the printer.
1 - Serial RS232 data I/O cable
2 - USB cable
Figure 2.2
Connecting the I/O Data cable
IER 506B PRINTER
User Guide
Ce document est la propiété d'IER et ne doit pas être reproduit ou communiqué sans autorisation écrite.
This document is the property of IER and may not be reproduced or communicated without prior written authorization
Page 13
N0B402A Rev. 3
Dec. 16, 2008