4 - HANDLING AND INSTALLATION
VIP80E
GB
4 - Pag. 21 / 21
4.9
CONNECTION TO THE POWER SUPPLY
IMPORTANT:
the connections to the power supply must be carried out following the
indications on the wiring diagram provided by the manufacturer.
The person who is authorised to carry out this operation, shall have special skills and
experience acquired and recognised in the specific area. He shall to carry out the connection to
the power supply workmanly, taking into account all regulative and law requirements, not only
concerning the bar feeder but also the connection to the lathe.
When the connection to the power supply is completed, before starting the bar feeder, inspect
if the above-mentioned requirements have been fulfilled.
Connect the multipole connector provided with the bar feeder to the lathe socket.
4.10
WORKING PARAMETERS SETTING
By means of a hand-held control you can assign the different parameter values according to the
operating characteristics of lathe - bar feeder coupling and to the working needs.
See the "Hand-held control instruction manual" in order to assign adequate values.
4.11
BAR FEEDER TESTING
IMPORTANT:
the bar feeder testing must be carried out following a preset procedure, which
is possibly indicated and authorised by the manufacturer.
During the bar feeder testing phase, check if the safety conditions are adequate and start it
only if this requirement is in conformity with the standards required.
Содержание VIP80 Evolution
