IEMCA Elite Evo Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 120 / 188

EN
6 - USE AND OPERATION Elite112_220_Evo_SIII
6 - Pag. 6 / 6
13 Selects the keyboard modes:
- with LED off ; selects the "message
display" mode.
- with LED on ; selects the "parameter
display" mode.
14 Multifunction
- Selects the next parameter
- Moves the selection cursor rightwards.
15 Sets the carriage movement motor.
During the daily use of the bar feeder this
function must never be used.
16 Opens and closes the clamps in manual mode.
Press to close and press again to open.
17 Magazine step by step forward button, every
time the button is pressed the bar in the
magazine moves forward by one step.
A Bar feeder start button (green light): press the
button to start the bar feeder and hold it down
until the button lights up.
B Bar feeder stop button (red): press this button
to stop the bar feeder and reset the "Errors".
C Remnant detection disabling button (white light)
Press the button to feed a "new" bar without the
detection of bar remnant in the bar pusher
collet.
D Half-bushes opening and closing button (white
light)
- In "Manual" mode, when the bar feeder is in
the required position, the half-bushes will close when this button is pressed. If pressed
again, the half-bushes will open.
- In "Automatic" mode, if pressed, the half-bushes will open and close, according to the
preset sequence. If pressed again, the half-bushes will remain open during the entire
operating cycle.