prox.pad Installation/Programming Manual
2.7.2.f Programming “Code OR Card” Users
To program a “Code OR Card” user use command 52. This type of user can use either their code or card to gain access. Codes can be
from 1 to 6 digit in length in any combination. Refer to table 6 for details on user types. The program sequence is as follows:
1. Enter Program Mode
Press:
99 # master code *
The yellow LED flashes slowly.
2. Program the “Code OR Card” User.
Press:
52 # user type # user location # code * repeat code * <present card>
3. Exit Program Mode
Press:
*
The yellow LED stops flashing.
2.7.2.g Programming 26-Bit “Card Only” Users via Batch Entry without Presentation
To program a 26-bit “Card Only” user via batch entry without presentation (without presenting the card to the reader) use command
56. “Batch entry” allows you to enter multiple, sequential 26-bit HID format cards into the prox.pad unit’s memory at one time.
(Keeping IEI proximity cards in order is easy as the code is printed on the front of each card.) Up to 1,999 users can be added this way
at one time. (User 1 is reserved for the Master code.)
NOTE: When programming cards with this command, you must program the facility code, using command 32, parameter 2,
prior to programming users.
To add several users, follow this procedure:
1. Enter Program Mode.
Press:
99 # Master Code *
The yellow LED flashes slowly.
2. Enter command to batch program users.
Press:
56 # (total number of cards to be added) # (starting user location) # card number * repeat card number *
NOTE:
Never enter one (1) as the starting user location since it is reserved for the master code.
3. Exit program mode.
Press:
*
Page 40 of 86 Document # 6055676, Rev 2.2, D4b