NANO-QM770 EPIC SBC
Page 55
Figure 4-13: SATA Drive Cable Connection
Step 3:
Connect the cable to the SATA disk
. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See
.
Step 4:
To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.
Step 0:
4.7.4 Single RS-232 Cable (w/o Bracket)
The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
Step 1:
Locate the connector
. The location of the RS-232 connector is shown in
Chapter 3
.
Step 2:
Insert the cable connector
. Insert the connector into the serial port pin header.
See Figure 4-14. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Содержание NANO-QM770-R10
