IEI Technology IVS-200-ULT2, Руководство пользователя

Страница: 29 / 116

IVS-200-ULT2 Embedded System
Page 17
3.3 Installation Procedure
To properly install the IVS-200-ULT2, the following steps must be followed. Detailed
descriptions of these instructions are listed in the sections that follow.
Step 1:
Unpacking
Step 2:
Configure the jumper settings
Step 3:
Install a SATA SSD
Step 4:
Install an mSATA module or a PCIe Mini card
Step 5:
Install the WLAN or WWAN module
Step 6:
Mount the IVS-200-ULT2
Step 7:
Connect the front panel peripheral connectors
Step 8:
Power the system up
Step 0:
3.4 Opening Bottom Cover
WARNING:
Over-tightening bottom cover screws will cause damage to the bottom
surface. Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
Before the jumper settings can be configured and the hard disk drive can be installed, the
bottom cover must be opened. To open the bottom cover, please follow the steps below:
Step 1:
Remove the bottom cover retention screws. The bottom cover is secured to the
chassis with six retention screws (four with foot pads attached). All screws and
foot pads must be removed (
764
Figure 3-1
).