VP5300 User Manual
Page | 12
3.3.
Low-Power Modes
The VP5300 has two low-power modes: Sleep Mode and Stop Mode. Power management is at the
discretion of the application developer and set with firmware command F0-03 (which is described in
the
NEO Interface Developers Guide
, available on request). Note that using the F0-03 command to
control the unit's power state is limited to RS-232 operation and is not available in USB mode. Also
note that when the VP5300 has been put in Stop Mode with the F0- 03 command, waking up the unit
causes a warm reboot, which can take 5 seconds or more. Waking the unit up from Sleep Mode does
not cause a reboot.
The VP5300 can be awakened in RS-232 mode from Sleep Mode or Stop Mode by sending the device
any command. In USB mode, establishing the USB connection wakes up the device.
