IDEAL Stripmaster 950, Руководство пользователя

Страница: 9 / 16

Service (Qualified personnel only; continued)
Circuit Board Adjustment
Replacement Circuit Board
Stripmaster
®
Model 950™ & 950-1™ Wire Strippers
Alignment Adjustments
Alignment
WIRE HARNESS CONNECTION
It may become necessary to replace the circuit board, in the unlikely
event of an electrical failure.
Your IDEAL Stripmaster
®
Model 950™ Wire Stripper has been aligned by IDEAL. After time, it may become necessary to realign. The following section
describes three different adjustments that are necessary to insure proper blade and guide alignment.
Adjustment Vertical
1. Remove top plate and slug tray.
2. Close blades using set up switch at top of machine.
It is helpful to use a light source beneath the machine to
illuminate the hole through the blade and bushing. Visually
check bushing and blade cutting holes for proper alignment.
3. Adjust set screws (use 1/16” hex wrench) located near both side
plates approximately 3 1/2” from the face plate, to raise or lower all
six blades to their proper vertical position if needed. Adjust both
sides evenly.
4. Install slug tray and top plate.
Adjustment Horizontal
1. Remove slug tray.
2. Close blades using set up switch at top of machine. It is
helpful to use a light source beneath the machine to illuminate the
hole through the blade and bushing. Visually check bushing and
blade cutting holes for proper alignment.
3. By turning both front left and front right set screws (use 3/32 hex wrench), repo-
sition the carriage left or right to obtain the proper alignment.
4. Install slug tray.
Important: Minimal side play is required for proper
alignment. But over tightening set screws will prohibit
carriage movement.
1. Remove the six #6-32 button head cap screws (use 5/64 hex
wrench) and the top plate. Locate the circuit board near the front
of the unit.
2. Remove the wire harness connector at the rear of the circuit
board.
3. Remove the four #6-32 button head cap screws (use 5/64 hex
wrench) on the circuit board.
4. Install the new circuit board and reverse removal procedures.
INCORRECT CORRECT
BLADE HOLE
GUIDE HOLE
9
INCORRECT CORRECT
BLADE HOLE
GUIDE HOLE