F
SECTION
XX-XX
PAGE X-X
ADS-AL(DL)-TL
PAGE 1-1
TYPE 3 - MODULE PROGRAMMING PROCEDURE - SMARTKEY PUSH TO START
8
Module Programming
Procedure completed.
7
Wait, LED will turn solid GREEN
for 2 seconds.
6
LED will fl ash GREEN and RED.
1
Open key fob.
2
Remove circuit board from key
fob.
3
Remove battery from circuit
board.
4
Place circuit board in front of
push to start button.
ENGINE
START
STOP
5
Push start button twice [2x] to
ON position.
ENGINE
START
STOP
x2
NOTE
I
When programming, only one key fob will be used. The other
one must be located at least 10 feet away from the vehicle.
ADS-AL(TB)-TL
16
ADS-TB-TL 16
TYPE 4 - MODULE PROGRAMMING PROCEDURE - NON-RFID PUSH TO START
5
Module Programming
Procedure completed.
4
Wait, LED will turn solid GREEN
for 2 seconds.
3
LED will fl ash GREEN and RED.
2
Push start button twice [2x] to
ON position.
ENGINE
START
STOP
x2
NOTE
I
When programming, only one key fob will be used. The other
one must be located at least 10 feet away from the vehicle.
1
Insert keyfob in keyport.
ENGINE
START
STOP
Page 69 of 71
DBI-TB-KO-EN
20131003
install guide
TraNSpONdEr BypaSS
KO
guides Français disponibles au www.idatalink.com
www.idatalink.com/support
automotive data solutions inc. © 2013
Doc. No.: ##12410##