a
SECTION
XX-XX
PAGE X-X
XX-XX
PAGE X-X
XX-XX
PAGE X-X
ADS-AL(TB)-FM 1-2
PAGE 1-4
MODULE PROGRAMMING PROCEDURE - REGULAR KEY
9
Module Programming
Procedure completed.
NOTE
I
To complete this procedure, both keys are required.
4
Insert key 2 into key slot.
1
Insert key 1 into key slot.
5
Turn key 2 to ON position.
(LED will turn solid RED.)
ON
2
Turn key 1 to ON position.
(Note: if the LED begins to fl ash
RED, please verify the RX and
TX connections between the
module and the vehicle).
ON
3
If LED turns solid GREEN for 2
seconds. Module Programming
Procedure completed.
If LED turns solid RED, proceed
with following step within 5
seconds, after LED turns OFF.
8
LED will turn RED to indicate
the learning procedure has
begun.
LED will then turn GREEN to
confi rm programming has
succeeded. The green LED will
remain illuminated until ignition
is turned off.
6
The LED will turn “OFF”
to confi rm the vehicle has
validated the key.
(Note: if the LED begins to fl ash
RED, you are using a cloned key
or used the same key twice).
Remove key.
7
Press and release programming
button and remote start vehicle.
OR
Jump the igntion to 12volts.
12V
IGNITION
10 AMPS
ADS-AL(TB)-FM 2
ADS-TB-FM 2
INSTALLATION MODE SELECTION
1
Press and release
programming button
to select installation mode.
2
Press and hold
programming button
until LED turns solid GREEN
to register selection.
!
After registration, follow Factory Reset Procedure to
change installation mode and restart this procedure.
LED fl ashes (1X) once = DATA MODE
LED fl ashes (2X) twice = STANDARD HARDWIRE MODE
Page 13 of 71
DBI-TB-KO-EN
20131003
install guide
TraNSpONdEr BypaSS
KO
guides Français disponibles au www.idatalink.com
www.idatalink.com/support
automotive data solutions inc. © 2013
Doc. No.: ##12410##